Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone integrated Avaya ACM3.0 running on S8700/G650 with CCM4.0.2? We are in process to propose this to customer but unfortunately we have no time to test this in lab.Has any one integrated above using QSIG? Which one is good? H.323 (Using MedPr...
Hi,Is this application licensed free to use with CCM4? Or I should have CRA server running? I want to redirect call which comes on a CTI port to the external destinations like PSTN and other locaitons connected to MGCP Gateway via tie line.What is th...
I am getting the below message with debug q931 on MGCP gateway confiugred for E1 PRI QSIG at IPC Dealer board side and T1 PRI to PSTN with CCM 4.0(2).Incoming calls are perfectly routed to turrets but outgoing calls from the turrets not getting route...
Has any one successfully configured the module in the subject for MGCP support with E1 PRI QSIG with CCM4.0(2)? Any issues in specific?Is onboard T1/E1 ports are accessible from gateway confiugraiton window of CCM for this module?Thanks!
I think the objective behind introduicng Linux based CCM is to minimize the administration effort to underlying OS. Many customers are looking for this kind of Linux based appliance solution. Competitor products like Avaya media servers known to be v...
When you use Cisco Voice VLAN feature, port need not be confiugred as trunk explicitly. Voice vlan information is negotiaed via CDP between switch IP Phone.Even if you configure switch port as trunk, there is no harm in it. Use trunk native VLAN for ...
If you enable priority queue, that queue is served first irrespective of the other queues. You need to map COS value to the respective queue (I think queue 1 is expedite queue when you enable priority queing).Please note that, QOS does not make any s...
Hi,In your case, the WAN link bandwidth does not match your switch interface speed. To avoid packet drop in carrier network, you need to either police at ingress or shape at egress. Cat3750 cannot do shaping, so use some router (like 1800 series) at ...
Hi Arijit,Actually I tested overlap mode initially later I changed to End block mode for testing.I guess the problem is with the route patter I have configured (I yet to verify this though). When I dial any number from turret, I dont see # prefix to ...
