Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure 2 9124AXD's (one RAP with EWC and one MAP) running ios 17.11.1 and the instructions say to click on the Mesh Tab but it doesnt exist. I have tried using different instructions and tried multiple times, but I am not able to ge...
I have 2 9130AXE directly connected to a 9800EWC and no matter what I try, they both state "AP Auth Pending" in Monitoring/Statistics. I am trying to create a Point to Point Mesh Bridge following the attached document. I have MAC addresses entered, A...
I found the solutions! I had to click on the wireless symbol at the top of the screen and select Advanced. Once I did that, the tabs for mesh and AP showed up. I dont know why Cisco made this as an option but this was it.
Thanks for the help but the AP joins the EWC every time. The issue is that I should be able to select the AP Mode as Bridge but the only items in the list are Flex, Flex+Bridge and Clear. I should see Monitor, Sensor, Sniffer, Bridge, and Clear but I...
Some more info on them:#sh verCisco IOS XE Software, Version 17.11.01Cisco IOS Software [Dublin], C9800-AP Software (C9800-AP-K9_IOSXE-UNIVERSALK9-M), Version 17.11.1, RELEASE SOFTWARE (fc2)
Hi Arshadsaf, I worked with a company SME to get that problem resolved and the problem was in my configuration. I was apparently trying to make the 9130 join the 9800 in Mesh mode with bridging enabled but the 9130 doesnt support any Point to Point l...
