Hi Nathan,Since you are able to ping from the router it doesnt look like a gateway issue, could you please send me the following outputs:1. show ip route2. ping 4.2.2.2 sou bvi13. show ip nat trans when pingingRegards,Sujit
HiThe logic that you used is correct, the only reason that this is not matching the traffic is because you have left the last octect as 0 in the mask. To match all the traffic the in both the subnets you need to have .255 in the mask in the last octe...
Hi David,Looking at the configs on R1 I'm a bit confused, all interfaces are configured as "ip nat inside", to NAT the traffic outside Serial0/0/0 you need to configure "ip nat outside" on that interface.Regards,Sujit