Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I couldn't find SPAN (monitor sessions) feature on ME3800 while I was browsing configuration guide and command references for 12.2.52. Neither can find anything mentioning it's not supported on that platform.Also checked cisco.com/go/fn but un...
Hi,We've recently replaced a 7200NPE-G2 with 7600-RSP720. We had around 1Gbps GRE tunnels terminated on the previous box with 85% CPU utilization comming from around 30 tunnel interfaces. Also running OSPF and some route-maps. Everyting was doing goo...
Hi all,I wonder what's the big difference between RSP-720 and SUP-720. both have almost the same feature set, performance and also same price. Anyone can explain in detail?This can also be applied to difference between 6500 and 7600 and narrow differ...
hey all,seems like a noob question but takes a long time with no answer ..., anyone knows where i can see the optic parameters of a SFP / GBIC on a cisco 6500 or 7200? i want to check Gain, loss, attenuation and other factors regarding optical interf...
Hi all,I've recently configured a destination NAT on a 6500 with Sup-720 the configuration is like this:--------------------------------------------------------------------------mls flow ip interface-fullmls rp ip input-aclmls rp ip route-mapmls rp i...
Dear Giuseppe,I have 2 tunnels at that moment, I changed the source IP addrsses and it actually fix the problem. Prior to that I had tested it while I had so many tunnles and couldn't see the quick impact on the router CPU but now with just 2 tunnels...
I've moved all the traffic back to previous 7200-NPEG2 except two tunnels for the sake of test only. Total bandwith currently in GRE is around 100mbps that's the output of show proc cpu :CPU utilization for five seconds: 28%/28%; one minute: 29%; fiv...
Connect a console to the switch, can you access the switch through console? check the device uptime in 'show version' and reboot cause. Check the logs using 'show logging'.
