Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 3 locations (B, T & R)The 3 locations will be interconnected with 3 E1 unframed lines. (visual: we have a triangle, corners are the locations, interconnected by the E1's)The hardware I use is 3x:Cisco 2621 with 1x VWIC-2MFT-G703Because the E...
I've a branch DMVPN network with 70 spoke routers and 2 hub routers. To create redundancy the hub routers are installed at different locations: if one hub router fails, eigrp & bgp routes the traffic via the other hub router.The DMVPN is based on DS...
I've a DMVPN up and running but if a node gets an other IP-address of the ISP or a router (node or hub) reloads it takes 2 - 3 hours before a new connection is established.I believe it's a timer problem (especially IPsec) But there are a lot of time...
I'm using DMVPN (1 mGRE Tunnel interface.)EIGRP runs on top of DMVPN with all nodes. Is it possible to specify/configure (on the HUB) which routes to advertise to a certain node (based on the nodes IP-address)? I've tried whith the "distribute-list...
Router "rpsaccess06" receives a route 192.168.99.16/28 via BGP and has to redistribute it into OSPF 1 (I use only area 0). A show ip route says that it redistributes it into OSPF but another OSPF router "rps-X25-TH01" doesn't have this route in it's...
Hello,The routers are using less then 10% cpu and memory: Total: 47309536, Used: 10693080, Free: 36616456The HUB's are running:12.3(5a) (12.3(5c) wasn't better) The spokes run 12.3(4)T3Summary of the problems:- SIA- Neighbors down, Up, ... When a ne...
There are only a few nodes which need extra routes. I'll configure the extra routes static at these few nodes.P.S. I was forgotten the multicast address.ThanksGerrit Vos