Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi ,i have Catalyst 2950 24 port switch and i am trying to run it in my store. i have breif knowledge of configuring cisco swtiches but google was/ is my friend and i was able to reset and factory default the switch to the original state.Now i have 2...
well you were correct i discovered that the switch works only with crossover cables and the installed cables i have are straight cables .and since the mini linksys (workgroup ) switch i was testing supports crossover conversion (mdix) , i was able t...
no there is not crossoverbecause the cable themselves work if i connect them to linksys wrt54g wireless router.so either 2950 is faulty which im sure it's not or simply i am doing a good job configuring the switch correctly
yes i can .now if you can give me a basic setup configuration for the switch i dont need anything beside all 24 ports to work. i have a clothing company and i don't need a complicated network herethanks for your answer
