Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello there, I hoping you are doing great. I wanna to use syslog to record anyconnect client connected event.I am using ASA5512-X (Software Version 9.12(4)30), below is my logging config on asa:logging enablelogging timestamplogging buffer-size 65...
hello, I wondering if ACL line number is equal sa number?Scenario:NY office has 1 subnet 192.168.0.0/24 and CA office has 2 subnets : 172.16.0.0/12 and 10.0.0.0/8NY and CA have a ipsec vpn.I wanna know it will generate 2 ipsec phase 2 sa ?
hello there,recently, we want to deploy Ruckus AP with cisco Catalyst switch.Our Ruckus AP is R650 and it support 1G and 2.5G link, so we want to choose a switch which suport 2.5Gwe found a model: C9200L-48PXG-4X-E and SPEC:Catalyst 9200L 48-port 12...
we have 2 new C9200L-48T-4X-E switchs and 1 new C9200L-24P-4X-E。we wanna to put 3 switchs in a stack, although there 9200 serials, but it's 2 different switch type.can we out those 3 switchs in a stack?
hello,I have over 5 years ASA experience, but I don't have any NGFW experience. I wondering if there have big difference between ASA and NGFW ? I mean in the command level...we use ASA for NAT, VPN (IPSec and anyconnect ) ,route, ACL etc...for those ...
@Milos_Jovanovic awsome !!!! you are right , it's UDP 443 caused it, my ASA is behind a NAT device, and after I allow udp443, the anyconnect become stable !!!!thanks!
