Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Experts,
We have installed Cisco ISR(ISR_1 and ISR_2) and Cisco FW(FW_1 & FW_2) as per photo below.
I already perform PERMITALL to each FW. So no blocking issue in FW.
We perform test FW_1 to FW_2 (using cross cable)without ISR, all the VLAN ab...
Hi Experts,
We have installed 1 unit 2504 WLC and 3 unit RAP. All RAP configured with the same configuration and tested before a
All RAP configured and done tested, all joined WLC.
After a year, I power up the WLC and RAP once installed at site, on...
Dear Cisco Experts,
I have got a problem to control the rules/traffic at the inside Firewall device. I have 2 unit workstation which the IP is PC-A is 10.1.0.101, 255.225.0.0 and PC-B are 10.1.1.125, 255.255.0.0.
This two PC is located inside port ...
Dear Cisco Expert,
I unable to perform static routing inside ASA interface.
If I perform command "ip routing" on my L3 Switch, I've trouble to control the L3 switch InterVLAN.
(I don't want VLAN 100(OLEO) and VLAN 101(ESTER) talk each other, Only VL...
Hi Expert,
I have a problem to join AP1523E to WLC2504.
I already configure the WLC and put the MAC filtering list of AP's.
For the Switch, I already configured port for WLC is "switch port mode trunk" and for RAP switch port as "switchport mode ac...
Dear Scott,
Thanks for your email.
I already perform as per you said. But it still not able to join WLC.
If AP connected to switch, we still able to see the MAC address even its not join right?
I perform command ''show ip arp'' in my WLC and in switc...
Dear Scott,
Thanks for your response.
I already perform the MAC Filter at the WLC.
Another 2 RAP is joined, but this one RAP not joined.
Really need to update the v8.2? because another joined RAP use same V8.0 also and no problem to join.
Really no...
Hi Leo,
Thanks for your response.
We already set the static IP. We use IP 10.51.14.13 for this AP.
WLC use 10.51.14.11.
Is it that true configured right?
interface BVI1
mac-address 381c.1a22.5be0
ip address 10.51.14.13 255.255.255.0
Thanks and be...
Dear Jon,
Thanks for the links.
I'll go through this documents and try to perform filter at L3 within VLAN.
Will update later if successful.
Thanks for your time.
Regards,
Hanif
Dear Jon,
Thanks for your comments.
Now used L3 switch, 3750 series.
Can configure something at L3 switch to block the RDP service?
Thanks,
Hanif Saharudin
