Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 2 2600s routers running hsrp, with two switches (4006) in between running trunking 802.1q. The trunking is working fine, the hsrp groups are set up on 1 interface and 1 subinterface on the routers. When this is set up, 1 hsrp group works as...
Hi,I am getting the following error in the event log of Windows 2000, CCM 3.3, when trying to upload the configuration to an mgcp gateway (1760V). "a connection was established then immediately dropped before completing registration"We can't upload ...
Hi,I am running VRF to remote sites on our network. This has been working fine, but 2 sites have been losing there internet connection, and to get it working again I have to clear the nat translation tables.Has anyone came accross this? I can still...
Hi,I am trying to block users in our network from using Kazaa and similar. I put the following in our perimiter router. access-list 120 deny tcp 192.x.x.x 0.0.0.255 any eq 1214 access-list 120 deny udp 192.x.x.x 0.0.0.255 any eq 1214access-list 100 ...
Hi,It is a good point, and the IOS is old, Version 12.0(5)T1. This had crossed my mind, but I found a page on the web site that said 12.0(8.1)T or later supported HSRP....it could be that it just does not support the 802.1q subinterface, I have so f...
Thanks for your response. The problem seems to be when we have multiple subinterfaces. We can have 1 standby group as active/standby on the subinterface, but any other subinterfaces with hsrp configured would be active/active, this was the case usi...
Thanks for your response. The problem seems to be when we have multiple subinterfaces. We can have 1 standby group as active/standby on the subinterface, but any other subinterfaces with hsrp configured would be active/active, this was the case usi...
