Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am a total beginner when it comes to load balancers. I would like to start from scratch. I ve seen a config for Cisco router's but i cant say i understand it . Can someone give me some material to understand this technology?
Hello guys,
I am new to BGP and i would appreciate if someone can give me a hint on what is wrong with my configHere is the topology
R1(BGP Router AS1) ----- R2 ------ R3(BGP Router AS2)
i wanted to make R1 and R3 BGP neighbors. All rou...
When i get to type this command
neighbor (R3's ip address) ebgp-multihop 3
this is the console message "% Specify remote-as or peer-group commands first"
so i tried to do it like this
neighbor R3-ipaddress R3-AS ebgp-multihop 3 and then it g...
