Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello and thank you in advance for taking your time to read this (I hope this is the right board for this question) This alarm is flooding the syslog of a Cisco CGR 2010 running Version 15.8(3)M.%FW-6-DROP_PKT: Dropping icmp session xx.xxx.174.12:0 y...
Hello, The config that it is working is simple switchport access vlan xx.The global configuration I cannot share. Asked my network Architect and he said it's best not to share, or if I want to share I should cypher all IP addresses and vrf's. As you ...
Hello @MHM Cisco World , Yes, first thing I did was to debug mab all, and I checked everything was working correctly. Thank you for the article, I will read it. Best regards,Tiago
Hello @Arne Bier ,Firstly I want to send you a big thank you for your detailed answer, It helped me a lot (a gave you the "helpful star") @Arne Bier wrote:First of all, the "authentication-session" vs "access-session" is a CLI change but the concept ...
I have done it:VIR-SW-01(config)#int fa0/4
VIR-SW-01(config-if)#access-session control-direction in
This operation will permanently convert all relevant authentication commands to their CPL control-policy equivalents. As this conversion is irreversi...
