Hi,How can I upload AA prompt file without going through wizard in SPA9000? I do not want to record through Analog phone because of voice quality.Regards,Wayne
I want to use one SPA504G at remote office which has leased line data connection to head office. The traffic needs to go through router so, it will be different network. Remote office does not have any PSTN line and I want one 504G to station there a...
My set up has AA handle all calls originating from PSTN. If the caller press "0", it will forward to hunt group. All set up is working but there is a 10sec delay after user press "0" and the response prompt "your call has been transferred". Is there ...
I have SPA9000 with 2 SPA400. It purchased recently. SPA400 configure for voice and another SPA400 for existing 4 PSTN line. I connected PSTN line to the RJ11 port of SPA400. I do not see the LED green light. I cannot make outside PSTN call. Do I nee...
Hi,SPA94X series is end-of-life. I recently purchase SPA9000 and waiting for SPA504G. Does SPA50X fully compatible with spa9000. I have a bit concern since I saw one post here that it has problem.Thanks
Thanks Steve. I raised this question because I did not see any ip information entry for SPA9000 in SPA504G. SPA504G comes with firmware version 7.1.3a. After I upgrade to 7.4.3 I can see "Linksys Key System Parameters" in SIP tab. Thanks a lot for yo...
Thanks for your reply nseto, we already have lease line between 2 sites. In layer 3 levels ip can be reach to each other but different subnet of course.If you can explain to me a little bit more about VPN with spa9000 it would be great help. We are u...
