Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,On 2620 Router is there any ios version that supports IPV6 ospf under interface config as shown below(config)#int fastEthernet 1(config-if)#ipv?ipv61(config-if)#ipv6 ?IPv6 interface subcommands: ospf O...
Hi all,After restarting the 1811w went into romon.i try the xmodem command it showsrommon 2 > xmodem -c c181x-adventerprisek9-mz.151-4.M6Do not start the sending program yet...dir: cannot open device "flash:"WARNING: All existing data in bootflash wi...
Hi all,I have ASA 5505 and Hi all, I have this issue, I save the configuration in the ASA 5505 using write memory or using copy run start but whe i unplug the power cord and plug it back in the ASA gets its factory default configuration.Please hel...
Hi all,i was reading about BGP and it says ----It is important to remember that when a BGP speaker receives an update from other BGP speakers in its own AS (iBGP), the receiving BGP speaker will not redistribute that information to other BGP speakers...
Hi Leo,Thanks for help.Seems Compact flash card in front of router pop up for some reason it put the card back and router booted the ios.Before this i try so many different things but it was not booting from flash as router was not seeing the flash.S...
Hi Karsten,Seems that fixed the issue.i can save the config now and did reload.config is saved now.Just last this sh bootvarciscoasa# sh bootvarBOOT variable =Current BOOT variable =CONFIG_FILE variable =Current CONFIG_FILE variable =it shows no file...
