Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all---R1------R2Both R1 and R2 run EIGRP. now there is the prefix 172.16.(1~255).0/24,and the summary prefix 172.16.0.0/16 coming into R1,Here has a problem: they require only can use "PERMIT" and named ACL at R1's interface which links to R2 to d...
---R1----R2-----R3----I got 3 routers, R1/R2 ran OSPF,and R2/R3 ran EIGRP, now, there're lot of routes that just like 192.168.(1～10).0/24 come from R1,i wanna redistribute these routes into EIGRP process on R2.but now ,they require that the 192.168...
Hi allIn ospf process,they require inject a default route to area 4, should i configurate the area 4 is a stub or totally stub area?one more a question:if i wanna an area in ospf process can only receive the inter-area route and must not receive the...
the 6500 supervisor 720-10G has 2 version, one is VS-S720-10G-3C,the other is VS-S720-10G-3CXL, if the version is defferent, you should not make the two supervisors redunduncy for SSO status
Hi,the 6500's arp expire time is 300 by default, when the time is expire, the switch can update the ARP entry in the ARP table.To solve your question, you can configure thestatic MAC address in your F5,Network-》VLANS-》configuration：advanced-》MAC Masq...
i'll take a try for your projectby the way , thanks for your attention this topic,can i make friends with you? my MSN:cj231514@hotmail.com, and you also can send E-mail to this mailbox.thanks again
thanks for your replyusing offset-list must adjust the metric to 2147483647, before i adjust the metricR3's eigrp topology tableP 192.168.9.1/32, 1 successors, FD is 284160 via 1.1.23.2 (284160/281600), FastEthernet1/0P 192.168.8.1/32, 1 succe...
