Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have a Cisco 2960S-48LPS which was loaded with the IOS c2960s-universalk9-mz.152-1.E.bin via xmodem using Tera Term. I can see the IOS in the flash directory fine and then issue the set BOOT flash:c2960s-universalk9-mz.152-1.E command. It...
Hello Cisco Support Community,Is it possible to create an EIGRP lab using routers which have ethernet interfaces only? None of my routers have serial interfaces. Labs I've seen on the Internet use routers which use serial interfaces as well as ethern...
I have split tunneling configured on a PIX 515. The remote VPN client connects to the PIX fine and can ping hosts on the internal LAN, but cannot access the Internet. Am I missing something? My config as per below. Also, I don't see any secured route...
I have the following VPN site-2-site configuration.The trouble I'm having is host 172.168.88.3 in site A is not able to ping 172.168.200.3 in site B and visa versa. Think I have added the static routes and ACLs correctly on the 3560 switches (acting ...
Hello,I have the following setup.host PC (192.168.9.3) -----> gateway (192.168.9.2) ----- Pix E1 (192.168.9.1)/Pix E0 (81.x.x.250) ------ InternetThe 192.168.9.2 gateway is a 3560 switch connected to the PIX. I can ping out to the Internet via IP fro...
Hi Carlo,I managed to rescue the switch. I deleted the flash that was already on there (just in case it didn't copy over first time properly) and repeated the xmodem procedure again, but using the BAUD rate of 9600, instead of 115200 as recommended o...
Hi Carlo,I don't want to start presuming what you mean, please could you clarify what you mean? As far as I can see in the flash directory, there is the ios, a config.text and a private-config.text.
Thank you Carlo, but have already tried using the BAUD rate of 115200 and 9600. Don't understand how the strange characters appear after what seems to be a normal boot up of the IOS.
Hi Jennifer,After adding the ACL it worked. Now the VPN client can ping the internal LAN. Many thanks for your time and effort helping with this issue.Many thanks to Singhsaju and mvsheik123 for your input too. Just want to say what a great forum th...
