Hi all, Iam having a 7606 router and it is directly connected by two swithces and one PC.One of the switch1 is the source of the multicast and destinations are are either in switch2 or PC.Iam having very limited concept strength in Multicas...
Dear Team, I have upgraded my Cisco 7206 VXR NPE G1 box from "slot2:c7200-p-mz.122-18.S6.bin" to "c7200-advipservicesk9-mz.124-22.T4.bin".The box is having cuople of POS ports with SFP ( SFP-OC3-IR1=). After the upgradation the port i...
Dear Team, Iam using SIP, SPA Interface Processor cards in 7600 box.Could any body clear me what is the value 200,400,600 in SIP-200,SIP-400,SIP-600 implies???Thanks in advance for any response!!!Mahesh Vijayan.
Hi all, Thanks for the response,but my SPA is not supporting the port-channel configs.Is there is any alternate to achieve the same. Many Thanks In advanceMahesh Vijayan
Hi all, also i ve found like some configs like below(as iam new o the setup)class-map match-all SNMP match access-group 98policy-map SNMPRESTRICT class SNMP police cir 128000 pir 130000 conform-action transmit exceed-action drop contro...
Hi , Also i ve seen the configuration like class-map match-all SNMP match access-group 98policy-map SNMPRESTRICT class SNMP police cir 128000 pir 130000 conform-action transmit exceed-action drop control-plane service-policy input SNMPRE...
Hi all, Iam sure like i vent applied any where...iam planned to apply in an SNMP command string.this is a CISCO7606 seriesIOS version is 12.2(17r)SX3How to see this Ternary CAM resources???Many thanksMahesh
Hi all, Still i am getting the same drops...also the cpu utilisation is getting higher.Once i ve created an access list then itself it is started incresing the matches to about 500-600 even though it is is not applied anywhere.EDGE1(config)#acce...