Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,I would just like to inquire about the behavior of the ports of the supervisor engines for both the 4500 and 6500. I guess this question may apply to other routers and switches with dual controller as well. 1. Are ports/interfaces for bot...
Hi! Good day! I urgently need help on how to configure aaa on a router to send accounting start stop attributes to multiple servers simultaneously.Thanks and Regards,Albert
I had a pending report (with status: running) in my IPSMC 2.1. The report had been running for almost a week so I assumed that it is not reponding anymore. I deleted the pending report but the "report running icon" in the top right corner of the wi...
Anybody know where I can download the fcs-IPSMDC-v2.1-w2k-readme.exe?The site http://www.cisco.com/cgi-bin/tablebuild.pl/mgmt-ctr-ids-app only view the fcs-IPSMDC-v2.1-w2k-readme.pdf file and no *.exe file. I am to upgrade my VMS to support IPS..Hope...
Help Please! I am having problems installing my Cisco works for our network utilizing SSH (secure shell). Are there any compatibility issues for both? When I do install the Cisco works on networks without SSH, the application works fine. Regards.
Hi Bjoern,Good Day! I really don't know how it is calculated but as based on our deployments, there is a +/-10% difference so it should be around 44Mbits/s. Please do note that there are a lot of services that are considered as P2P and you should con...
Hi!For sure, network clean-up is such a difficult task especially if you have a huge network. But to make it simple, you can do the following:1. Audit your network and include the following- network topology- network connections (active and inactive)...
Hi!Old PCMCIA cards usually those that are 24mb below would require an emulator before it can be read on a laptop. As for the new ones which are termed as ATA PCMCIA (usually 48mb up), these can be inserted and read on the laptop and yes you can put ...
Hi! I then suggest you do the following. Try checking your UTP cable. Another is try connecting this same PC to another port. It's right that you should verify if there are VLAN configuration on the switch. For further isolation, try replacing the LA...
