Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying configure Cisco2821 for ISDN video using E1 PRI. I have looked into the documentations and configuration looks ok. The only thing I do not understand is how to configure 'voice class called number inbound/outbound' for secondary called...
Hi,I will be doing an upgrade for Cisco Unity 5.x from Exchange 2003 to Exchange 2007. I will be following this guide http://www.cisco.com/en/US/docs/voice_ip_comm/unity/5x/upgrade/guide/ex/5xcuruge130.html#wp1359133. Could someone please tell me wha...
Hello,I am using CUCM7.1 and have successfully set up Cisco Unified Mobility. My question is if a user makes a call using mobile phone (remote device), can that call be pickup by or swtiched to the desk phone without dropping the connection? Many tha...
Hello folks,I have upgraded CUCM 4.1(3) to CUCM 6.0. But Cisco CallManager service is not running, though it is activated.I have not uploaded the phones and node licenses yet. Would Cisco CallManager service not run without license or it is a differe...
hello,I am trying to upgrade CUCM from 4.1(3) to 6.0. When I install DMA 6.0(1)a to CUCM4.1(3), after installation I am not able to open CCMAdmin, DMAAdmin and any other pages. But when I uninstall the Informix Dynamic Server and DMA, the CCMAdmin an...
Carlo,You are a star!!! This post has made my life much easier.. I have one final question and then I will let you go. You have 3 video endpoints 727085, 86 and 87 but in the voice class pool you have given the end numebr to be 727099, may I ask what...
Hi Carlo,Thanks very much for this info. I have two questions here for you:1. What are your H.323 video endpoints in your network? i.e. Where is your dial-peer 9998 is sending IP calls to?2. Looking at your config, you have voice class called number ...
Hi Paolo,Thanks for your reply.What I am trying to do is to configure the 2821 voice gateway to make and receive ISDN video calls. I don't understand how to configure the voice class called number inbound/outbound numbers on the voice gateway. For ex...
