Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Am trying to find a way,where only some members of the port-channel would be used until the load increase the active member capacity .If this is not possible,Also exploring a way to keep some member active and only other members become activ...
Hi All, We are trying to figure out a command to identify whether a SFP is plugged in on the SFP port of the inbuild gigabit ethernet port on the Cisco 3845 router.Any help is really appreciated.ThanksRegardsAnantha Subramanian Natarajan
Hi All, We are trying to log the no.of hits for a permit ACL statement ,which is applied to an interface on a ML100 card but couldn't see any hits.So we are tring to capture the port traffic and send to a port where a sniffer is connected but couldn...
Hi All,I am trying to understand,how routing works in the ASA for the site to site VPN tunnel subnets.When I look into an ASA configuration to understand the site-to-site VPN configuration ,which is working,it doesn't explicitly have a route for the ...
Hi All, We are trying to figure out prioritizing voice traffic to around 20 percent of the link bandwidth in the outbound direction on WS-X6408A-GBIC by the below commandpolicy-map <name> class <name> priority percent 20!class-map match-any <name>...
Hi Ralph, Thank you very much and we were able to confirm that.We have one more question based on that,when we plugged in GLC-LH-SM,the "show interface" o/p showed media type as LX instead of LH.Is both are same ?Any help to understand this would be...
Hi Mklemovitch, Thanks for the response and seems acl logging is not supported on ML card.If you know any other ideas,please let us knowThanks RegardsAnantha Subramanian Natarajan
