Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone, We're seeing these messages in the logs of a couple of WLC's configured to be anchor controllers. The two WLC's each have a dhcp scope that is part of the same network. WLC1 has a scope of 10.60.48.1-255, a network of 10.60.48.0, a netm...
Hi Everyone, I've a 2950G that from time to time logs the Internal POWER supply is FAULTY message. The switch is operating normally, it's not rebooting and isn't connected to an RPS. The IOS version is .121-22.EA8a. Has anyone any idea whether this ...
Hi Everyone, I've been asked to report on my 1200 device network on how many switches only have a single uplink. I've got LMS 2.6 and would appreciate any thoughts on how to generate a report to show this, best wishes, Mike
Hi Everyone,We're trying to spot machines that haven't been used on the network for a few months as we're going thru an upgrade programme. There's users out there that occassionally plug stuff in that been sat in a cupboard gathering dust and we'd li...
Hi Everyone , I've got LMS 2.5.1 with CM 4.0.5. If I try to view the report of Campus Data Collection I get "An error occured in generating Discovery Details report. Unable to load properties from server. Please try after sometime." we're trying to f...
Hi, the code upgrade didn't fix the problem, the switch has continued to work but the CLI showed psu fault. We plan to replace the switch just in case the psu suddenly dies, best wishes, Mike
Thanks again for your answer Scott.If you've seen an identical problem and escalted to the TAC then I guess there's nothing we can do other than ignore the messages until a guest wireless solution that supports redundancy is supported.best wishes and...
Thanks for your answer Scott, the problem seems to be with the two anchor controllers acting as active/active instead of active/standby. Both are being handed DHCP requests over their EoIP tunnels by foreign WLC's on what looks like a round robin sc...
Hi, thanks for your response. The lease time has been configured to 10 hours.Normal DHCP operarion though is for a client to contact a DHCP server and request the same IP address provided the network address hasn't changed. My assumption is that beca...
