Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Resulting in limited speed of 288 Mbps, rather than supposedly 866 Mbps on 80 Mhz (.11ac).I have tried disabling DCA, setting custom channel to 80 Mhz, but my devices can only get 20 Mhz. Happens on various firmware from oldest to latest.What's stran...
I can’t access the WLC through GUI or SSH from its configured IP from outside its subnet. It can only be accessed from the same subnet with WLC’s management/WLAN IP.
WLC IP:
10.1.1.1/24 Mgmt
Clients from 10.1.2.0/24 can ping 10.1.1.1 but cannot acces...
I just implemented 2 firewall (fortigate) units with high-availability and setup their VRRP interface that is connected to a single core switch (3650). When testing, the failover process was success but the problem is on the switch couldn't forward t...
*Please refer to the attached topology.
To eliminate single point of failure and provide redundancy, usually we configure HSRP at the gateway that is usually a L3 switch or a Router. On ASA this feature is not supported, so how to configure the ASA a...
In our production network, we have a MPLS VPN for the remote office and recently we just deployed an ASA NGFW as an edge firewall and I want to create a backup S2S VPN if the MPLS link goes down.
So I tried labbing it up and my configuration seems ...
40 Mhz also stuck on 288 Mbps. I've tried setting it on channel 36, but my devices somehow can't detect the SSID on that channel. And there's no interference/obstruction issue.
There's literally no other 5Ghz SSID in my neighbourhood. Another interesting find as the screen shot is the AP already broadcasting 80 Mhz but no client can't get traffic above 288 Mbps. Even my wifi 6 device is also stuck on 288 Mbps with this "ent...
Ok so this might be a bug or something as I'm not able to access the controller from another subnet. All of the controller's IP are pingable from other subnet, but to access the GUI/SSH I need to be in the same subnet as the controller's IP. Really w...
Does it mean I need to disable the mgmt via dynamic interface first so that I'm able to access the controller from subnet that is not defined on the controller?
