Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have six LAP1142N-A-K9 access points and just purchased an additional access point (same model) to provide coverage in an area of our building. It is connecting to a WLC2504 controller running software version 8.3.143.0 but I cannot get i...
Hey folks, I've work for a small college. I have seven Cisco Aironet 1142 APs' in my network. They have been working fine forever, but this morning I came to work and wireless is down. In the controller, all the APs are showing as rogue, and I'm at a...
ok, so I reset the AP again, logged in, went into privilege exec (#) using "enable" command. typed capwap ap primary-base controllername ipaddressThe AP starting upgrading and is now online and joined in the WLC Haydn.....YOUR ARE THE MAN!!!!!!!Thank...
I'm trying that now. Is there a way to transfer the config file from the working ap to the non-working ap? Would that solve the problem? AP5057.a84e.6d7f>capwap ap primary-base WLC1 209.165.200.225^% Invalid input detected at '^' marker.
Got my console cable. Below is the output from a working AP and then the non-working APWorking AP output:using eeprom valuesWRDTR,CLKTR: 0x87000800 0x40000000RQDC ,RFDC : 0x80000034 0x00000209using ▒▒▒▒ ddr static values from serial eepromddr init do...
I'm having the same issue as the original poster of this thread. Can someone summarize what was done to get this issue resolved? I'm just struggling to understand the exact steps taken.
Thanks Haydn. I'm actually waiting on a console cable to come in the mail from Amazon.I tried the factory reset (I think I did it correctly) by powering off the AP, holding the mode button while plugging power back in and releasing the mode button af...
