Hi all,
I have a mobility express controller which it's switch port is an access port.
As soon as I change it to trunk, the controller will become unreachable.
What is the problem? I have another environment with the same APs and controller and...
Hi,
I want to set a default gateway on a layer 3 switch for VLAN 100.
If I give an IP for interface VLAN 100 does it work or do I need to set it on an actual interface (port - example: int g1/0/1)?
Thanks
Hi,
I have a Cisco Catalyst 3750X.
I tried to create sub interfaces but it is giving an error. I am assuming that these are not supported on this device.
1. Can someone confirm if they are supported?
2. Are there any switches that support sub int...
Hi,
I am trying to understand the DHCP snooping feature. I understood that this feature is to prevent rogue DHCP Servers.
From what I can understand, if I have a network on VLAN 10 and I have 50 users, I need to enable DHCP Snooping on all 50 ac...
Hi,
Can someone give me a quick review of what is EIGRP stub, OSPF for routed access and EIGRP stub routing? How do they differ from the EIGRP and OSPF in the IP Service switches?
Thanks
Thanks for the update.
I got the following when I tried the above:
(config)#int GigabitEthernet1/0/41(config-if)#no switchport(config-if)#int GigabitEthernet1/0/41.10 ^% Invalid input detected at '^' marker.
I want to create a new subnet 192.168.1.0/24 and set 192.168.1.1 as the default gateway of the VLAN.
My question is does the 192.168.1.1 need to be set on the int VLAN 100 or the g1/0/1?
Thanks.
