Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloIt seems that load balancing is also supported for webvpn but I do not find in configuration if we have to install the same certificate on the cluster menber for ssl ? Is somebody try this feature before ?thanks Olivier
HelloIs that option "Close all opened browser windows upon installation" available on securedesktop configuration can work with the couple cache cleaner and the ssl vpn client ?We have tried and with that option activated, the ssl vpn client is disco...
Hello My problem is that with RIP on a PIX, we can't advertise outside network on the inside, but this is possible with ospf. Which protocol is correctly inplemented in PIX OS ? if both, which next release will support RIP to work like OSPF ?thank in...
Hello I would like find an explanation of that message, I find at the end of a show version on a catalyst 6500 running 5.4.3 :WS-C6509 Software, Version NmpSW: 5.4(3)Copyright (c) 1995-2000 by Cisco SystemsNMP S/W compiled on May 31 2000, 20:17:28Sys...
Thanks for your responce, Yes, about the issue, the backup is working, but if the router reload or is power off, at the power on sequence, the configuration stopbits 2 is not use during the boot , and then the backup do not working after, ... becaus...
Thanks a lot for your responce about dot1q tunneling, but can I connect a catalyst 2950 whitout dot1q tunneling and a catalyst 6k which run dot1q-all-tagged for other connexion in dot1q tunneling ?
HI,See the datasheet for gigabit module on catalyst 6K :http://www.cisco.com/warp/public/cc/pd/si/casi/ca6000/prodlit/c60ge_ds.htmThe module only support Switch fabric switching mode.You can verify it with the software advisor, I suppose.regards
