Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having fits getting these devices to learn VLAN information. Does this even work when the device is set to layer 3?I have tried setting the port to general, access, and trunk. I have enabled GVRP globally as well as on the interface. I would l...
I noticed an ACL applied to a radio interface on our APs, and I was wondering why. bridge-group 1 input-type-list 201bridge-group 1 output-type-list 201access-list 201 permit 0x8895 0x0000access-list 201 deny 0x0000 0xFFFFI understand the permis i...
Hey everyone,I am attempting ot access the GUI web interface of cisco aironet 1242AG Access Points. We are using Air Fortress as our ACL and auth. appliance. I have port 80 allowed open for management on the APs. I took over this role from an admi...
I am attempting to upgrade 41 cisco aironet 1242AG access points. I am receiving a timeout error and no data is being transmitted. We are upgrading from 12.3(8)JA2 to 12.4(10b)JA1. We are using Air Fortress as our wireless auth. appliance. What I'...
Is there any way to manipulate the flow of traffic on a network?It has become necessary for our campus network to have all traffic on port 80/443 go through a smart filter server. Due to the current set up of the network, access control lists would ...
I've read through that and still am having issues? I guess if someone could answer at least one specific questions, I could maybe make someprogress....1. Will GVRP work with these in layer 3 mode?Thanks,Rob
Scott,Thanks for the reply. The APs aren't set to use port 443. Port 80 is the active port. I spoke with the admin who is no longer with us and she informed me she did use a different password. Thanks again.
