Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I upgraded my Cisco SG350-10MP switch to firmware version 2.5.9.16, the switch is up and running fine but I can not longer login into it with any of the credentials I have for it. I updated the credentials, save them and tested that I could login. Th...
I just installed a three cisco c9200 in a stack to replace an existing stack, and created uplinks/port-channels back to a core switch. The only thing plugged into the switch are the uplinks to the core. We are seeing a small 16port switch connected t...
First of all read the whole post before you try to answer and yes I have tried all the standard things like changing the speed, updating the drivers on my pc, usb ports, serial to usb cable, flow control all the standard stuff. I am on the right com ...
I have been trying to reset a password on a Cisco SG350-52P without doing a factory reset, I found this link
Administrator Password Recovery for 300, 350, 500 and 550 Series Switches - Cisco
But it did not work on the Cisco SG350-52P it wouldn't even...
Thanks very good information, is there a way I could have known this was an issue ahead of time. So what is the fix? password recovery or factory reset?
Thanks I already have that document, I am remote to the device so I was hoping to find another solution other than a password recovery process which requires me to travel onsite. I have 50 more of these switches to upgrade the firmware on and need to...
