Hi Good day,
May I request for advice on what went wrong on my laboratory. During the set-up process PC A, B and C can ping each other and works well
I configured necessary interfaces, networks and loop back, use auto summarization for R1 and manua...
Hi Good Day, Hoping that someone can advise me why I cannot ping the router from inside the firewall. I have this basic network with end devices inside the firewall that is connected to a switch, I was able to ping all the devices inside the firewall...
LANGood day, I'm new to networking and currently working on an activities LAN Redundancy, it's doing good until such I have to change port cost in the non-root switches, but it won't work. When I type --> S1(config)#int f0/1S1(config-if)#spanning-tr...
Hi, I'm new to networking and currently encountering problems when I ping the router from pc and pc to router. Per our activities we used router, multilayer switch, switch and end devices such as pc and printer. 1. Router can only ping multilayerswit...
Sorry see below correction highlighted in blue;
But what is strange for me now is, I did not use any
hold-time
command and If I did used it, running
hold-time eigrp 1 180
after the hello-interval it doesn't work, thus, I just ignored the
hold-time...
Oh, thank you so much and appreciates it. Below is the credentials for my lab.
Device Password : ciscoExec-Mode Password is : class
I tried to change some configuration in hello -interval from 60 I lowered it to 5 and the error was...
