Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Running 3.8 and when I get alarms like interface threshold limit violations from Auto Monitotring it lacks an interface's description.Is it configurable?
Running 3.8 and looking for a way how to send SMS if a particular event/alarm occurs. I have only two options how to do it:1) if a alarm occurs then execute a script on Cisco Prime2) if a alarm occurs then send it to (my) syslog SMS gateway is standa...
I have a strange situation where wireless AP's MAC flaps between trunks a on switch.Flapping occurs in AP's management vlan (VLAN ID 99).Also AP's MAC is seen in data VLANs (VLAD ID 10 and 20).AP is Ubiquity and switch is Catalyst 3750 G (15.0-2.SE10...
This works on SG300, but not on SG350:
conf t
int gi1
switchport mode trunk
switchport trunk native vlan 111
switchport trunk allowed vlan add 20
switchport trunk allowed vlan add 30
Last two lines are merged into single one when sh run int gi1
swi...
It's Ubiquiti not Cisco after all.Disabling Enable connectivity monitor and wireless uplink in site settings in Unifi SDN Controller solves the problem.More info: https://community.ubnt.com/t5/UniFi-Wireless/Wireless-uplink-causing-network-loop/td-p/...
%SW_MATM-4-MACFLAP_NOTIF: Host 788a.208c.xxxx in vlan 99 is flapping between port Gi1/0/1 and port Te1/0/1Management VLAN 99 is dedicated for APs and it's different than management VLAN for switches.I do not utilize wireless mesh.All APs are Ubiquity...
Let's take a look on my problem from a general view.
I need to define 3 MAC addresses which should be allowed to communicate through a switchport.Since the switchport is a trunk, I'd need to specify a VLAN, so I'd issue this command: switchport port-...
