Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently the only way to match EPs into an EPG is using VLAN, as we don't have VMM integration to use useg, there are HP enclosures that have limitation of 128 VLANs and we reached that limit, so now we are stuck in creating more EPGs.
Does anyone...
Hi All,
I wanna share with you some of the best practices that should be applied on ACI:
Bridge-Domains Config Best Practices:
1- Always enable Unicast Routing even if it is a L2-BD (That's help in learning the IPs so it will help in troubleshoot...
Hi All,
I'm wondering if there is anyone can explain how N1Kv VSM communicate with VEM module using separate l3 interfaces on both of them, the main concern how the VSM know the IP of the l3 vmkernel interface of the VEM to communicate with it?
Hi All,
The source class ID is the pcTag of the consumer EPG (16387) and the destination is a reserved pcTag (0) not 15, 15 is the priority, pcTag of 0 is used for vzAny to represent any EPG in a specific VRF (scope)
You can use EtherChannel guard to detect an EtherChannel misconfiguration between the switch and a connected device. A misconfiguration can occur if the switch interfaces are configured in an EtherChannel, but the interfaces on the other device are n...
Hi Bill,
Have you checked the supported topologies here https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/aci_virtual_edge/installation_upgrade/2-x/Cisco-ACI-Virtual-Edge-Installation-Guide-201/Cisco-ACI-Virtual-Edge-Installation-Guide-...
