Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
DearsI had cisco MDS 9148S SAN switch , i upgrade the device from 8.4.2 to 9.3.2 but i can see from server side Pathes for storgate are not working could plz advise about that ?Bests
Hello DearsWe are planning to impelment Cisco ISE with 802.1x and we have the following quiestions :1-is it possible to connect ISE with Microsoft AD so the login user for 802.1x is done with AD username/password?2-is 802.1x is working without issue ...
Hello Dearsi have the VPC configration between the two swiches when i reload the master VPC nexus switch there is a downtime about 1 min while this not take place since the firepower devices are confiagred as Active/Standby and also the vpc that goni...
Hello Dears and thnx for reply could we authenticate 802.1x without ISE certification i am need the user just checking by username/password not using any authenication method anyone can help ?
hello dear and thnx for reply , i put that but in syslog side the information like interface up/down and same stuff is not appear and also for login failed as an exmple is also missed
hello dearthe connection is simple we had two FTD nodes going to two Nexus switches each FTD box has two connection to N9K-1 and N9K-2 and for configration : description To Firepower-vPCswitchportswitchport mode trunkspanning-tree port type edge trun...
