Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am attemptting to configure a SF500-48p switch to do the followingUse port 1 as VLAN 100, use port 2 as Vlan 200 both of these are untagged Vlans, then use port 3 as a trunk for both the vlans which would be tagged.I am attempting to use both the G...
I am attempting to block all FTP traffic on port 21 from the servers in my network, and only allow FTP from one server to go out.I have created the following ACLaccess-list 101 Permit ip any any access-list 101 Permit 21 1.1.1.1 0.0.0.0 anyaccess-lis...
To allI have a Cisco ASA and have a client that has a NetScreen 5200 and we are seeing issues on the ASA that show the error below %ASA-4-402119: IPSEC: Received an ESP packet (SPI= 0x0C970ED6, sequence number= 0x5B7B) from (Remote End) to (Local End...
I am new to the Ace module world and have configured what I feel is a working configuration for load balancing, as its working, but the question I have is How does one use the GUI interface I have chnaged the www user password but all I see is a scre...
I have attempted to upgrade my 4210 IDS sensos both via the upgrade ftp and upgrade scp from an ftp server as well as useing the IDS as the host and both do not work.When I attempt to use the upgrade scp from the sensor and have the host sensor key s...
When I attempt to use the configurations above the switch becomes non reaachable as I am attempting to do this over a VPN connection.So the question is do I need to insert the config as follows access-list 102 permit ip any anyaccess-list 102 permit...
Hey adakopouI have found the ANM software and was able to donload it but the issue is we run a MS shop here and the requirements state a dedicated Linux box, is there anything similar tio this tool that run on a windows based system?Thanksdavid
When I run the upgrade scp there are no errors before the system reboots. The version I am at prior to the attempted service patch is S47.I have copied what I see when the rebot happens below HPSH_SCCIC04(config)# upgrade scp:// User: XXXX...
