Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone!I have an IR829 that has two VLANs setup for wireless and wired clients. I can't access any wired vlans devices from the wireless vlan. Please help me diagnose the problem Thank you!TestsFrom the router I can ping all the devices from the...
Hi,I have the following setup and I have the HUB and SPOKE connected through a IKEV2 tunnel using FlexVPN. The problem is I can't ping remote subnets from either router. 172.16.5.0 VLAN @ ISR172.16.5.0 VLAN @ ISR172.16.11.0 @ CSR (A loopback just for...
Hi legends, I'm trying to figure out a way to connect a Cisco router that has a cellular connection through a VPN. The router is on a moving vehicle and the cellular connection is behind a NAT and does not have a public IP. The basic requirement is t...
I'm trying to connect to a linux server running a VPN server using a Cisco IR829 router. I can ping the VPN server from the router but when I look at the L2TP debug messages it says "172.16.4.143 is unreachable" Here's the debug log. Apr 29 06:28:07....
Hi! I have a Cisco IR829 router with a cellular connection to internet. I need it to connect to a IPSEC-PSK VPN server (With a publicly accessible IP) hosted on my server, as a client.All the examples I found on the internet are going from a Cisco de...
Hi Georg,I made the change and it seems to retain all the inter VLAN connectivity. I have internet on VLAN20 but VALN10 doesn't have internet now. Here's the test I did to verify. Show ip route gives me this,Could you identify any problem? Current co...
Hi Georg,Thanks for pointing me in the right direction. It started working once I made your changes.I'm hoping to use PBRs to give internet access to the vlans from different interfaces. Vlan10 shoud go to the internet from the Cellular0 interface an...
Hi Rob,I'm back at the router. I've added the routes manually and I'm still getting the same SA on the HUB. I'll look at EIGRP to see how to set it up.What would be the reason for this not to work? It's doing NAT-T but I assume its not the issue here...
