Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day all.
Added a 3rd member to a stack (24 ports on each switch) and all the ports show up in SHO INT STATUS, but the second switch does not show in SHO VER. And our LogicMonitor is showing "Stack Port StackSub-St1-2 ON OR227-XAH1 is down."
Th...
Came across this curious "sh int status" results on a non-stacked Cisco WS-C3850-12XS switch. This is an OT switch and it would be nice to know how to get it so that the gi ports read 1/0/1-24. I was thinking in global configuration mode. Issue the...
Hello all, A coworker showed me a page that would compare switches side by side. My company deletes all emails after 3 months. And apparently, i didn't mark the bookmark OBVIOUS enough. I have Googled with no results. Can anyone help me out. Many ...
Good day all,I have a switch with no IOS, nothing in any directories. When trying to copy c3560cx-universalk0-mz.152-7.E1.bin from the usb to flash it comes back with :unknown error. Should i run a format next?After pressing return after copying the...
Leo! My mentor...you just don't know it!The original post Switch 01---------Switch uptime : 46 weeks, 5 days, 16 hours, 30 minutes There's 52 weeks in a year correct? This is 6 weeks shy. A month a half at least. Switch Ports Model SW Version SW I...
In the original post "* 2 41 C9300-24P 16.12.4 CAT9K_IOSXE INSTALL" show that switch 2 is the master indicated by the "*" to my knowledge. I appreciate you chiming in!!!!
Usually, but the attached image is from a Cisco web site...and of course I cannot find the link because I took a screenshot. But here's the other diagram.
