Hi, all..At my Cisco 3750 switch I have 2 vlans...vlan1 and vlan 100. In both vlans the switch has an IP-addresses..I can succesfully Telnet to the vlan100's ip-address.Trouble exists if I try Telnel to the vlan1 ip-address. Sure, I use a router for ...
Hi all,I know, that local-directory service displays NAMES that configured under ephone-dns. That's good.But...I don't understand why some entries still displayed, if I've delete ALL names under ALL my ephone-dns. Why is that? How can I fix it?
Hi all,I have CCME and NM-4B-U network module in it.Cisco.com recommends connect a BRI U port with straight-through cabel...and I did that. NT1 led lights green. That's ok....Layer1 and Layer2 are OK.===========CCME_2811(config-if)#do sh isdn stGloba...
Hi all, I've got an error on cucme 2811 router. SW ver is - 12.4(22)YB / CME 7.1 There are more than 30 names (42 exactly) in the directory at my cucme router.... And if I try to view all names at phone's display, then error appears (XML[4]:Parse err...
Rick, great thanks !!!You are right.If PC connected to the port in vlan301 (for example), so I can telnet only to the IP-address of the 3750 in the vlan310, but not in any other vlan.Could you explain me why is that?
RickI was wrong about vlan100...sure a PC is connected to the port in vlan301. PC connected to the Cisco 2960 Switch...and at 2960 port is in vlan301. 2960 connected to 3750 through trunck link.vlans 1 and 301 are exist at both 3750 and 2960 switches...
RickVlan1 interface is UP.PC is in vlan100 "subnet". IP connectivity is OK. From my PC I can ping vlan1 interface on 3750 switch.SH run and Sh ip int brief are in attachment.According to my config, my PC is in vlan301. PC connected to the cisco 2960 ...
