Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Folks,I have a 2 Cisco switches with 40 Gig optics in each. One side sees light on all 4 channels and everything looks good. The other side does not see light on 2 of the 4 channels. Where to start troubleshooting? I have tried different ports on ...
We recently upgraded from a 9396 to a 93180. Most of our ports are getting output errors. The following is some info from one port. 1/9MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usecreliability 255/255, txload 15/255, rxload 1/255Encapsulation ARPA,...
I am looking to install a PA-GE interface in a 7206VXR. I do not have a processing engine that will support Gigabit speeds. However, I only need 200 meg out of this setup. Is it possible to install a PA-GE and link up at Gig speeds but only get ar...
Side BEthernet2/1 transceiver is present type is QSFP-40G-ER4 name is CISCOSOLIDOPTICS part number is QSFP-40G-ER4 revision is 1A nominal bitrate is 10300 MBit/sec per channel Link length supported for 9/125um fiber is 40 km...
Side Athernet1/53transceiver is presenttype is QSFP-40G-ER4name is CISCOSOLIDOPTICSpart number is QSFP-40G-ER4-LCrevision is 1Anominal bitrate is 10300 MBit/sec per channel Link length supported for 9/125um fiber is 40 km cisco id is 13 cisc...
