About tonycraig

tonycraig · 05-12-2010

Hi,Just new to this community hopefully someone will be able to help me out. Then as my knowledge increases hopefully I'll be able to help someone else out!I'm using a 2821 purely to provide ntp to the network. It is set as ntp master 12. If I config...

tonycraig · 07-07-2010

I mean was the firewall also natting? I suspect that also had a nat table. Your nat pool to HP only has one address in it. Without using overload this is only going to map one address hence why only one device can connect.

tonycraig · 07-07-2010

Did you have a saved config for the firewall or did you config it from scratch? Where is the outside nat table?

tonycraig · 07-07-2010

Can I see the config for the serial and the controller? I think your SP must be running it as a full 2meg possibly throttling via a map. I would check with them. This is reasonabley common. I know for a fact Eircom use this method, It allows them to ...

tonycraig · 05-12-2010

Thanks for the advice.So if I set up my remote site routers as followsntp server 1.1.1.1 Data centre Antp server 1.1.2.1 Data centre BHow will each remote site determine which server to take the ntp info from?Sorry to ask more questions but if i end ...

tonycraig · 05-12-2010

We have them deployed as back up routers at a few hundred sites. We also use them as primary routers for over 2000 smaller sites. No major flaws to report. Seem pretty robust.If only the DSL they connected to was as reliable.Tony

Member Since	‎01-27-2006 07:41 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	6

User Statistics

User Activity

How to configure a secondary NTP master?

Re: Intermittent VPN connection - newbie

Re: Intermittent VPN connection - newbie

Re: chanelised E1 configuration issue

Re: How to configure a secondary NTP master?

Re: out of band managent router - which one?