Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm in a bit of a bind. We have an office with 10 APs under an Embedded Wireless Controller on AP1. To give some background, we set things up with more or less default settings when moving in three years ago and it worked well. I am just a simple rou...
So this all takes place on a Catalyst 9200 Layer 3 switch, where VLANs have virtual interfaces (SVIs). I have several networks of 10.1.x.x that are our main data subnets (VLANs 25, 26, 29, 30). There is a lab network (VLAN 20) at 172.16.20.0 /24 that...
Hi,We noticed that on one of our phones in particular, the 8861 (which is connected to the network wirelessly due to lack of available ethernet ports at that desk), the volume sounds rather faint, especially with external calls, even if the volume is...
I want to set up a VLAN 20 (172.16.20.0 /24) to have internet (which it does) but not be able to reach any of the other VLANs on the switch. However, I want the other VLANs on the switch to be able to reach it (say VLAN 26 at 10.1.26.0 /24 and VLAN 2...
Hi, it seems HTTPS should be enabled and activated for the EWC, but I'm still getting the no https indicator on my browser when going to the IP for the web GUI:What other steps should be taken?
to 17.12.6aEither the newer code is better at finding a good balance between the different APs regarding transmission power and channel usage or the upgrade forced a true, deeper reset of the RRM in a way that the other things I tried did not?
Admittedly it does say the controller is running "deferred code": 17.6.4, and recommending to migrate to a more recent version.As for the clients, at times it seems it is more smart phones that have problems, and sometimes laptops, but less frequent...
I can try that. I will say, however, that AP2 and 6 are on opposite ends of the office, and AP10 and 4 are pretty far apart as well (though admittedly AP4 is blasting at 17dBm now and 10 at a measly 8). Would co-channel interference still impact thin...
PSK. Fast transition is not enabled as I feel that would make our hyper-roaming situation even worse. Client traffic is trunked out to the AP with flexconnect.No errors on the switch ports that I can see. However, there is some flapping, and again I ...
