Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently was setting up a port channel on a Cisco 9300 and with my first config the ports were suspended. Here's what I had.Port Channel configinterface Port-channel1 description DC-ExpInet switchport access vlan 2 switchport mode accessPorts confi...
I have a 9200 with 5 vlans setup. vlan 10, 12, 13, 15 and 100. All have interfaces. I can ping all of them but vlan 10. I'm not seeing the issue. I running the ping from the switch... Why is it not showing as a connected vlan on show ip route?!inte...
I've setup ssh logins on my older 2960s and I get a warning that I can't find anything to clear. Here are the settings I have.AAAaaa authentication login telnet localaaa authentication enable default enableaaa authentication dot1x default group radiu...
Ok, so if no one is connected then the interface will not ping? 90% of the ports on this switch are access and assigned to vlan 10... But, no one is currently on, so all the vlan 10 ports are "notconnect"... The other vlans 12, 13, 15 & 100 all have ...
Ok, interesting... Why would it be status: up, Protocol: down...#sh ip int briInterface IP-Address OK? Method Status ProtocolVlan1 unassigned YES NVRAM administratively down downVlan10 172.25.10.1 YES NVRAM up downVlan12 172.25.12.1 YES NVRAM up upVl...
