Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have few aps model: AIR-AP1815W-E-K9 with the ios version:8.5.151.0 that have uptime of more than 100 days, but the association time stays 1 hour or less, and reset.They losing the connection with the controller.They operate in flex-connect over...
Some ports of my nexus sport to work, I checked the log and collected this messages:
2018 Aug 8 11:43:11 swa.001 %PLATFORM-2-MOD_REMOVE: Module 2 removed (Serial number JAE18160R11)2018 Aug 8 11:43:13 swa.001 %PLATFORM-2-MOD_DETECT: Module 2 detect...
I need to access my ACS server , but he is showing that is locked due failed logins.I tried to do a power cycle in the server, but the error still the same...How could I solve this?
Today I started deploy a cisco 1602 autonomous, but the client asked me to configure two different ssid's. I did,two different ssid's and two different vlans. My question is, should this access point operate in bridge mode ? I will connect this dev...
I am facing this trouble above.
I have many other devices connected in this port, all no cisco and no manageable.
I don't have idea what can be,and I have a loop problem in this interface ":%STP-W-LOOPBACKDET: gi1/1/12: STP Loopback Detection.", I ...
thank so much for your reply,using "show ap join stats" i got something that look interesting:Sync phase statistics
- Time at sync request received............................ Not applicable
- Time at sync completed......................................
Thanks a lot for your reply, I really dont think is a cable problem, we have more than 200 aps, in different places with the same problem....I tried to enable debug on the controller, but I really dont know if this is ok,,, debug ap enable AP1_SITEA...
I moved all cables to another module.
But now I am having problems with my VPCS:
%ETH_PORT_CHANNEL-3-COMPAT_CHECK_FAILURE: Module Type Incompatible is not compatible
What can be Incompatible type module ? his number ?
Thanks
Than you.
My configuration looks like yours.
But I won't connect to a switch, I will connect to a firewall, with sub-interfaces, and each sub-interface has an ip.
So I can't have a default gateway.
Why bridge mode doesn't work ?
Thank you again for...
