Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,Good day. Please note that i have read the manual from the switch but I would like to ask you what is the difference between PSE Port support: 24 ports and 4-port AF/AT (Ports 1-2, 13-14) ?https://community.cisco.com/t5/small-business-supp...
Dear All, Good Day. Please note that I have 4 buildings and each building has 2 L3 distribution switches and 12 Access. All L3 distribution switches go to 2 core L3 switches and i have configured ospf single area 0 between core and dist L3 switches. ...
Dear All, Good day.I would like to ask if it is a good technique assign the network address of the wlc management interface and dhcp-server into vlan 99 general management, i.e. configuring the vlan99 access port for the dhcp,wlc interfaces connected...
Dear All, Good day. Please i need some advise here for hsrp where i must to configure. The SVI distribution L3 switch must to configured with seperate default gateway for each vlan(for example for vlan5SW-DIST1(config-if)#ip address 172.16.12.1 255.2...
Dear All, Good day. Please can you advise me, because I am studying the case for designing a layer 3 network and I want to ask where the dhcp-server should be located. My apologies for the picture.
Thank you for the prompt reply. I have 3 AP 802.3af/at can i connected to any port i want or only to 4-port AF/AT (Ports 1-2, 13-14) from the switch?Thanks
Thank you for the reply. Bellow i have an example from my topology Build - 1i have created vlan 99Dist-1 -> 172.16.99.1Dist-2 -> 172.16.99.2HSRP -> 172.16.99.3Access-1 -> 172.16.99.4 i have enable ssh with ip default-gateway 172.16.99.3and in the osp...
Dear Flavio, Good day. Please note that the: dhcp server has two ethernet adapters and by default when you open the dhcp server it shows the Giga ether interface, but you can choose the fast ether where it is configured for the vlans.Thank you for yo...
