Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am using avaya cm4.0 to connect cisco CUCM6.1 through IP H.323 trunk. The voice call is working fine without any issue when enter dtmf information after listening to IVR promts it is not reaching to CUCM and call is getting tranfered to agent....
Hi,I am having two dc switches with FWSM modules installed. DC switch1 FWSM (Ver 3.2(12) is wokring as active and Secondary DC switch2 FWSM (ver 3.2.(12) is in standby mode.From yesterday I am trying to login primary FWSM, It is accepting my use...
Hi,Hi,I am having two dc switches with FWSM modules installed. DC switch1 FWSM (Ver 3.2(12) is wokring as active and Secondary DC switch2 FWSM (ver 3.2.(12i) s in standby mode.From yesterday I am trying to login primary FWSM, It is accepting my usern...
Hi, We are having two 6500 series switches in same floor. In First switch 6748 line cards is installed with DFC-3 card.In our Editing workstations are connected to this line card for higher cache as well performance. In second switch I have installe...
Thank for your prompt response.In another cisco document for H.245 it is using tcp ports range 11000- 65000. These ports cann't be open due to range is wide range.Can anyone clear about H.245 tunneling or inband DTMF on cisco H.323 trunks.Thanks in A...
Hi,Could you please find module details below.------------------ show module ------------------ In 6513 where everything is working fineMod Ports Card Type Model Serial No.--- ----- --------------------------...
Hi,Thanks for your response.What will be impact when i will switchover truncated and whatis Cisco's recommendation. If i switch-over to trucated do i require reboot. can any one help on this.
