Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I think i'am missing something here. I've recently been attempting to get standalone point/head IW9165DH aps up and running, with a switch attached remotely on one AP so we can have that switch online in a industrial area over the wireless ...
Hi community,Have a 7000 running 8.4 and only selection seems to be md5. As per guide (https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus7000/sw/system-management/config/cisco_nexus7000_system-management_config_guide_8x/configuring_ntp.h...
Good morning Cisco Community, I feel like i am over looking something simple here. I've built a SVI and propogated it into OSPF on a L3 device. On one interface of that device there is a host connected through two cascaded layer two acces switches....
Hello community, It's my understanding that tcpdump and ethanalyzer only capture at the control plane natively. Judging by my use of them not capturing anything otherwise, this does seem to be true. I need to do some ICMP captures on interfaces so i...
Hi community,I think this is something likely small i am over looking. I'll try to be brief in my description here, and will answer any further questions. In the past, we had a setup with two nexus 9 series in each "hub" data center. In each hub, a n...
Again thanks for the help. I guess that's the part i am still getting hung up on, since i just set my native vlan to a dummy vlan and set the aps to 0 and i can still manage the switch, so it does appear to be sending it untagged somehow. However, ...
Alright, but given the cisco configuration it looks like if i have the license enabled (which i do), and vlans enabled (which i do) and management vlan and native vlan matching (which i do), and the trunks on either end matching with native vlan and ...
Sorry, didn't notice the link before thanks to mobile settings.Am i safe to assume from that document then that if i'am in scenario b, untagged traffic should be sent across in a untagged envelope which is stripped at the mesh end and sent onward the...
Ok, i'll let that one stew in my head for a bit. Thanks for the help again.Is there a way to somehow map a vlan to go untagged > tag in uwrb? Using L2TP is a possiblty for me, but since my switches are in l2 domain and are 9300s i believe i would end...
