We have 4 CUCM in PUB-SUB scenario1 -PUB and 3 SUBs with cucm 6.0everything was working fine but from last few days we are facing an issue,Phones registered with Subscriber A can communiate with phones on Subscriber B and C bothPhones registered to S...
Hi,I have implemented SNR in cucm 6 and i want to know how can i transfer call received on a mobile phone back to desk phone. There is a service parameter of for transfering call *84 but its not working.Regards,Iftikhar Ahmed
Hi,We are getting an error message "The Agent or workflow initiated action request fail"whenever there is an Supervise transfer of call by an agent.Checking previous topics i have also confirmed that "Caller Number" and "Redirected Number" both are ...
Hi,Can any one tell, how can we identify from gateway that what is the disconnect frequency received from PSTN on FXO port. My problem is the PSTN provider is sending frequency which is not identified by frquency locale for my country.Regards,Iftikha...
Can you please give detail of the issue? is the phone displaying showing word "Private" on idle state of it shows private when call rings on the phone?if this only with one phone, better to check the privacy setting of phone.
Hi,I have checked realtime SDL traces and i see following Remote NodeId: 1, AppId: 300, Address: [10.100.200.12:8004]000549312| 2009/12/12 15:51:05.838| 012| SdlError | | | ...
Hi,Thanks to all of you for replying,As i posted earlier, there are no issues with WAN link, link between these two sites is STM1 link with no packet loss and latency around 12ms.MTU for the network path is 1500.If it is a Bad NIC issue then problem ...
One more thing everytime when problem starts i see following in application log just before SDL errorDec 11 12:01:01CMSUB-ISL-IPTNoticelogrotateALERT exited abnormally with [1]Is it something that is creating issue?Regards,Iftikhar Ahmed
