Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
We recently bought C1121(X) routers. however. we are unable to configure the router as the configure terminal command shows as not supported on the router.
Cisco IOS XE Software, Version 16.12.03Cisco IOS Software [Gibraltar], ISR Software ...
Hi,
I have Cisco C9500-40X-A, C9200L-24T-4X-E and C9200L-48T-4X-E. I need to upgrade the firmware versions of these switches. and im having trouble to find the most suitable IOS version to upgrade.
Appreciate if you all can help to get the recommend...
Hi,
I'm preparing
C8300-1N1S-6T BOM to replace 3954-VSEC-K9
router. It has Cisco
3945E
Voice Sec Bundle,
PVDM3-64, UC&SEC Lic,FL-CUBE10
I'm bit confused as how to VSEC license for C8300 router? Do i need to add
DNA-P-T2-A-3Y
license of
L-DNA-C8300
l...
Hi Guys,
I'm trying to create a read-only user in Cisco c9407R switch with only show privileges. I tried to do it by creating a privilege 5 user and assign privileges. however when i log via that username, show commands not working.
Appreciate any ...
Hi Guys,
I'm trying to create a read-only user in Cisco c9407R switch with only show privileges. I tried to do it by creating a privilege 5 user and assign privileges. however when i log via that username, show commands not working.
Appreciate any ...
Hi Reza,
Thank you for the reply,
I have small doubt with that option. In the event of uplink port failure of the primary core switch, would the traffic flow via secondary core switch to the secondary firewall.
Thanks
Hi,
Basically Core switch will act as a L2 switch. Firewall will act as the gateway for the Vlans. so basically trunk uplink will be configured between firewall and the core switch.
