Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,suddenly the DNA GUI is not working also there is no ping at enterprise IP or cluster IP.after launch KVM from CIMC (Cisco integrated Management Control ) i got page have the following options :- start a cisco DNA center cluster- join a cisco D...
Dears,is there any method to know if the console cable is connect to device or not ?we have switches in different location, some of them is connected with console cable, i am looking if there is any method to know if the device is connect with consol...
Hi Dears,we added some switches to our DNA center, after that we notice the DNA login to switches many time at a day. this process effect on our ISE system. therefore is there any method to limit the number of DNA center to login to switches even Res...
Hi Dears,I have two Switches C9500-24Y4C, i upgraded them from version 16.12.4 to 17.3.5, after reload when run show version i got two different reason for reload :Switch 1 :Uptime for this control processor is 2 hours, 9 minutesSystem returned to RO...
Dear @Kasun BandaraThank you for your reply.i checked with # show line , i got the following:- when the console is active, there is a (*) mark.- when the console is not active , there is no (*) mark.-----my issue is not related to active console sess...
Hi @Leo Laohoo i tried with these commands, but it is did not work sh log uptime detaildir flash-2:/coredir crashinfo-2#dir flash-2:/core^% Invalid input detected at '^' marker.#dir crashinfo-2%Error opening bootflash:/crashinfo-2 (No such file or di...
