Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I start AnyConnect default configuration and can enter username and password.Authentication works, but not authorized to open full tunnel.Please check debug messages below.Now I try SSL-VPN with anyconnect to Cisco 1111!Getting following debug messag...
Dear friends,
I need to summarize routes from the backbone area to connected areas!
The line in the config of the ABR looks like:
router ospf 2area 0 range 10.4.0.0 255.255.0.0area 1 range 10.2.0.0 255.255.0.0
The routing table on a router in...
Dear Friends,
now I tested on GNS3 and I have a solution!
Thank you all!
Please see also att image001.png, which is not complete!
My mistakes in due to misunderstanding of OSPF:
I tried to summarize the network 10.4.1.1 which is in area 8!The sum...
