Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Before I open a TAC case, I tought I'd bounce this one off everyone.I am experiencing an issue which occurs with IOS 15.0M and which does not occur with IOS 12.4(24)T1. I have verified this by reverting to 12.4 on a production router where I experie...
Given an event manager applet set to trigger with an "event timer countdown" or "event timer watchdog" statement, is there any way of viewing the current timer status (i.e. remaining time until trigger)?
I've noticed something idiosyncratic with respect to the behavior of the IOS Embedded Packet Capture (EPC) feature in IOS 12.4(22T).I have a DMVPN virtual tunnel interface (IPSEC encrypted). When I apply an outbound-only EPC capture point for cef-swi...
One of our routers, a 3825 running IOS 12.4(22)T1 has been reporting non-process (i.e. interrupt-related) CPU utilization in the 60%-80% range, with peaks even higher. We are not actually experiencing any performance issues, and I have followed the ...
Does the "tunnel bandwidth" statement (not the regular "bandwidth" statement as applied to a tunnel) apply to mGRE tunnels?The only Cisco documentation I've seen regarding this statement has been in the context of RBSCP (Rate Based Satellite Control ...
I had posted the original message two years ago. The solution we wound up using, which is a little bit different, is as follows:The approach we're using relies on setting a reaction-configuration that generates a trap (trapOnly) and using the "ip sl...
Unfortunately the AnyConnect Premium license, which allows for this, costs more than 100 times as much as the AnyConnect Essentials license, so it's a non-starter for us. I would like to pose a simple, basic question: Is there any practical, meaning...
Two years later, and I've come across the same problem on an ASA 5505 running 8.2(2).It only manifested itself after entering a new activation key (which may have altered memory allocation in order to accommodate the additional authorized features).N...
Problem solved (apparently).TAC finally came through. Although the previous configuration worked under IOS 12.4(24)T2, it is apparently now necessary to use the very misleadingly named "remote-peer" option on the reverse-route command.Basically, my ...
