Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the C9200L-24T-4G-E switches and would like to upgrade them to support 10GbE SFPs. Is it doable? or should I replace them by C9200L-24T-4X switches? if it is doable, is there any instruction on that?
I'm about to start a software upgrade of Firepower 1010 from version 6.6.0 to 7.1.0. I understand it is allowed to run the direct upgrade. There two files I have:1) Cisco_FTD_SSP_FP1K_Patch-7.1.0.1-28.sh.REL2) Cisco_FTD_SSP_FP1K_Upgrade-7.1.0-90.sh.R...
I've purchased two C921-4P routers from Amazon to run them as Home-Agent routers under IP Mobility deployment. However, they don't support IP Mobility, complaining "Protocol not in this image". I know this router supports IP Mobility as we have other...
I've upgraded FMC from 6.6. to 7.1, and now it requires to deploy the upgrade to the managed device (FPR1010) which is still with 6.6 version. Should I go ahead and deploy this upgrade, or should I first upgrade the FPR1010 from 6.6 to 7.1?
Thanks for the insight!The VM's memory is 32GB. Based on the guide it should be sufficient. The VM's hard disk is 250 GB. Should be good too. So, i consider following steps for my upgrade:1) Install Cisco_Firepower_Mgmt_Center_Upgrade-7.1.0-90.sh.REL...
I've just found solution for this. IP Mobility is working now. I've just typed the below commands and rebooted the router.license boot level appxk9license boot module c900 technology-package appxk9
BB, Is any other potential reason of Mobile IP not supported by the 1921 router? Based on Cisco Feature Navigator, it should support if its IOS is Version 15.4(1)T2. The bellow is output of "sh ver" command:Router#sh verCisco IOS Software, C1900 Soft...
