We have 4 servers on a 3750G with 2GB etherchannels for them. The other day some computers could not ping the servers and the servers could not ping each other (all servers were on the same switch and could ping end devices on the LAN and over the W...
Hi,I'm looking to monitor some high use switchports on a 3750G. I'm looking for something that will send an alert should a port become around 90% utilized. Any suggestions? Thanks
I'm trying to setup a port channel from a 2960G to a 3750G and I'm getting (Not connect) on the 3750 when I do a sho int Po1 command. It shows connected on the 2960. When I do a sho eth sum on each device things look good both ends show that they a...
The port channel is up and connected. The change I made was creating po6 and re-assigning the appropriate switch ports to it. . Not sure why the 3750G didn't like port channel 1.
No shared port on the 3750G. I did notice the 2960G has dual purpose ports, but those are ports 45-48.Every port on the 3750G shows up as "configured as a connector" The media-type command is unrecognized on the interfaces or while in global config...
Thanks for the reply. I mirrored your config and I'm still getting down, down, (not connect) on the upstream switch...what do you think about the media-type configured as a connector statement below? It's the only difference I see when comparing my...
Hi,Here is the out for sho int po1 on the downstream 2960G:sho int po1Port-channel1 is up, line protocol is up (connected) Hardware is EtherChannel, address is 0021.5610.2102 (bia 0021.5610.2102) MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, ...