Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I work for a network performance team and we were asked to monitor the CPU Utilization for a Cisco 7613. It was thought (by Management) that turing on SNMP would cause the CPU to be over utilized. We usually poll the device via SNMP to gather this in...
I monitor Perfomance for a Large Network. We noticed that an ATM Subinterface has been dropping around 30,000 Packets per hour. We looked at the higher level Links and they are running clean with low utilization. The Util on the Sub interface is runn...
I am a performance Manager for a Large Network and we retrieve Performance Data Via SNMP. A customer found that one device was not recieving Data for one of the GRE tunnels. All other Interfaces on the Device were being Polled and collected on (Via S...
What is the Command to disable Dynamic Trunking Protocol on a Catalyst 4006 Switch? I thought it was #switchport mode access, But It will not accept the word Switch as part of a command. Any Ideas??
I am a Network Performance Manager for a large network. We recently were having problems with DTP packets from Cisco Switches causing ifinunknownprotos on the Cisco Routers. We have also identified ifinunknownprotos on the Cisco routers from Juniper ...
Giuseppe, Just wondering if you had any further information on the errors i am seeing on this AAL5 Interface or a possible solution on how they can be fixed. Thanks,Jim R.
Giuseppe, Yes I have a Flexwan card, I am guessing you wanted the Model number??It is WS-X6182-2PAIf that is not what you were asking for please let me know, Thanks for all of your help.
It is a Cat6506 S72033_rp Ver 12.2MTU= 4470 Bytes75500 KBDLY = 80 usecThere are Out Dropped packets on two of the three Subinterfaces and well as the Physical Int.
